Usually, you should assign addresses on the same private subnet. The two units must have different addresses. Normally, the unit with High priority is the master unit.Įnter the IP address, with netmask, that this unit uses for HA related communication with the other FortiAuthenticator unit. Set to Low on one unit and High on the other. Both units must use the same interface for HA communication. This interface must not already have an IP address assigned and it cannot be used for authentication services. Select a network interface to use for communication between the two cluster members.

To see a list of index numbers and their corresponding time zones, enter set tz ?.

For example 15:10:00 is 3:10pm.Įnter the current time zone using the time zone index. Valid format is two digits each for hours, minutes, and seconds. For example: set date sets the date to August 12th, 2014.Įnter the current time. Valid format is four digit year, two digit month, and two digit day. This is the default route for this interface.Įnter the current date. Once this port is configured, you can use the GUI to configure the remaining ports.Įnter the IPv4 address of the default gateway for this interface.

Netmask is expected in the /xx format, for example 192.168.0.1/24. You can also enter ? for help.Įnter the IPv4 address and netmask for the port1 interface. The commands can be used to initially configure the unit, perform a factory reset, or reset the values if the GUI is not accessible.ĭisplay list of valid CLI commands. The FortiAuthenticator has CLI commands that are accessed using SSH or Telnet, or through the CLI Console if a FortiAuthenticator is installed on a FortiHypervisor.

Fortinet support for mc3200